Remote Receiver Lok
for Zinger Winger Bird Launcher Remotes

Zoom Image

The Receiver-Lok is a universal "Receiver Anchoring System." No more problems trying to secure your remote receiver to a bird launcher. Use the Receiver-Lok to attach and remove the remote receiver without tools or mechanical fasteners. Constructed of tough molded plastic, the Receiver-Lok is tough and will last for years. The Receiver-Lok attaches to your receiver using high quality adhesive tape. Don't worry  about Velcro straps, lost bolts and broken snaps again. The Receiver-Lok is sold in packs of 6 (enough for 3 launchers and 3 receivers).

Order the Zinger Winger Remote Receiver Lok

Zoom Image

Remote Release Mechanism
(to upgrade from Manual to Remote)

Zinger-Winger Remote Release Mechanism Upgrade

Zoom Image

Multi-Shot™ Sound Release

The Multi-Shot Sound release is installed on all new Zinger Wingers™ Bird Launchers except the Zinger Winger II G3 and Uplander G3 Bird Launchers. The Multi-Shot Sound release are Precision engineered to be the most reliable bird launcher release system available. The Multi-Shot Sound release can easily be retrofitted to older Zinger Winger bird launchers or other remote launchers.

Order the Zinger Winger Multi-Shot Sound Release

Zoom Image

Sure-Shot™ Sound release

The Sure-Shot Sound release is installed on all new Zinger Winger II G3 bird launchers and Uplander G3 bird launchers. Precision engineered to be the most reliability release available, the Multi-Shot Sound release can easily be retrofitted to other remote launchers.

Order the Zinger Winger Sure-Shot Sound Release

Zoom Image

Servo Replacement

This servo will operate with your Dogtra or Tritronics remote release electronics. Comes with pre-wired bullet connectors.

Order the Zinger Winger Servo Replacement

Zoom Image

6-Volt Solenoid

This 6 volt solenoid replaces original Zinger Winger bird launcher solenoid. Can be used on other devices where 6 volt solenoids are used. Steel plunger is included.

Order the Zinger Winger 6-Volt Solenoid

Zoom Image

Replacement Plug Retrofit Kit

Broken plugs can be replaced without soldering. With the Zinger Winger Replacement Plug Retrofit kit you can replace all the original Zinger Winger 1/8” 2 pole plugs. Also fit Dogtra and Tritronics remote receivers. No soldering required. This kit Includes 1 soldered plugs, 2 bullet connectors and instructions. 

Order the Zinger Winger Replacement Plug Retrofit Kit

Zoom Image

Replacement Plugs (2 per pack)

1/8" 2-pole plugs to replace original plug on all Zinger Winger electronics. You can get your winger back up and running in no time at all. Soldering is needed to attach plugs to your existing wire. Sold in packs of 2.

Order the Zinger Winger Replacement Plugs

Zoom Image

Replacement Wiring Harness Kit

This Replacement Wiring harnesses from Zinger Winger includes an 1/8" 2-pole plug attached to 65" of 16 gauge wire. Two quick connects allow you to easily replace your broken and damaged wire harness.

Order the Zinger Winger Replacement Wiring Kit